Filter
Top Products
BenQ DC 5530 User’s Manual
English
Using the DC E510
6
3.2 Capture Mode
1. Press the POWER button to turn on the camera.
2. Press the Capture mode button [ ] until capture
mode is enabled.
3. Compose your image in the LCD monitor.
4. Press the shutter button down halfway (1), then press it
down fully (2).
• Pressing the shutter button down halfway automati-
cally focuses and adjusts the exposure.
• The focus-area frame turns green when the camera is
focused and the exposure is determined.
• When the focus or exposure is not suitable, the
frame of the focus area turns red.
• If the photographic preview is set to "ON", the cap-
tured image will be displayed while the image is
being recorded onto the memory.
Notes
•
The LCD monitor darkens in strong sunlight or bright light. This is not
a malfunction.
• To prevent your images from being blurred while pressing the shutter
button, always hold it carefully. This is especially important when you
are shooting under low lighting conditions, which your camera may
decelerate the shutter speed to ensure your images are properly exposed.
• To review the last-captured image, press the button. Press the
button again to return to the camera mode.
1
Press down halfway
2
Press down fully