Filter
Top Products
18. Using the Cycle Print Mode
2-33
Scanner
Chapter 2
After entering the Cycle Print Mode,
press the Start key to start.
NOTE
• After the first scanning operation has
finished, the system will automatically
scan the next image following a preset
period of time. The system will continue
to operate until the Cycle Print Mode is
canceled.
• The “No. of Copies” value flashes
during the “scanning” and “waiting”
operations.
• The next scanning job can be started
manually by pressing the Start key
before the system automatically initiates
the same job.
To pause an operation during the
Cycle Print Mode, press the Clear key
(the “No. of Copies” value will
switch from a blinking display to a
constant display).
While the pause function is enabled,
it is possible to exit the Cycle Print
Mode by pressing the Clear key a
second time (the value displayed in
the “No. of Copies” display will
change to a “1”.)
1
Start
2
3
Operating in the Cycle Print Mode
0820771003.book Page 33 Monday, March 19, 2001 2:49 PM