Filter
Top Products
Operating Instructions
111
8. Select the transfer method, and click [Next>].
• Clicking [<Back] takes you back to the previous page.
• Clicking [Cancel] takes you back to the Trigger page without saving
changes.
Note
• If you transfer images by E-mail or FTP, confirm that the default gateway
and DNS server addresses are assigned correctly (see page 48 or page
53).
Enable Post-
trigger Image
Buffer
• Check the box to enable the setting. The camera buffers or
transfers the image right after the alarm signal is detected.
• Set an interval, number of images to buffer and total
number. The number of buffered images may not match
the total number (see page 191) due to memory capacity,
image resolution, image quality or what object you view.
Setting Description
No Transfer, No
Memory
Overwrite
• If the internal memory or the SD memory card is full, the
camera stops buffering.
No Transfer,
Memory
Overwrite
• If the internal memory or the SD memory card is full, the
camera deletes the old images, and continues to buffer the
image.
FTP • The camera transfers the image to an FTP server (see
page 112).
E-mail • The camera transfers the image by E-mail (see page 114).
Setting Description